80/100A/200A/300A ESC USB software connection and parameter description

This article will teach you how to connect the USB parameter board and the parameter description of the software. The USB parameter board is suitable for ESCs: Feather 80A ESC, 100A ESC, Feather 200A ESC, 200A/300A ESC.

Step 1: Connect the ESC signal line to the parameter board, the orange line to the yellow line, and the brown line to the brown line. As shown in the figure below:

Step 2: Open the software compression package, then open the software folder, and finally open the application. Wait for a few seconds, and an option will pop up. Just close it;

After closing, the software interface will pop up. You can set the language in the upper left corner. There are two languages, Chinese and English;

First select the com port, select com4 or com3, depending on which port the current computer is connected to;

After selecting com, click connect. At this time, connect the ESC to the power supply and the parameters will be displayed;

Step 3: Click read parameters to read the current parameters of the ESC

Step 4: The following explains the functions of various parameters

Step 5: After setting, click write parameters to save, and then click read parameters to check whether it has been saved;

After saving, disconnect the power supply.

If you have other questions, please feel free to contact us.