Knowledge

This article explains how to adjust the underwater thruster set if it yaws. First, turn on the remote control. If there is a "lock" icon on the remote control screen, it means that the remote control is locked. Therefore, we need to unlock the remote control. First, turn off the remote control, press and hold the 6-channel button, and press and hold the remote control power button at the same time. After turning on the power, release the button to complete the unlocking. If the boat yaws to the right, use the lower left corner fine-tuning key to adjust the...

This article explains the difference between unidirectional ESC and bidirectional ESC First, we demonstrate bidirectional ESC, using 30A Feather ESC and 16V power supply voltage. Turn on the remote control and connect the ESC plug to the power plug. Connect the three-phase line of the propeller to the three-phase line of the ESC. Connect the signal line of the ESC to the receiver, and insert the signal line into channel 1 or channel 2. Pay attention to the direction of connection. The white line is connected in the direction marked with numbers. After connecting the power supply, wait for the...

This article explains the difference between ESCs with BEC and without BECWhat is BEC?BEC: Power module, used to power servos or receivers. The BEC voltage of general ESCs is 5v, 7v, 12v, and the current is 1a, 2a, etc. (Power supply module) ESCs with BEC power module: This type of ESC has a built-in BEC module, and does not require an external BEC. It can directly obtain power from the battery and power the receiver and other control devices through the BEC module without an additional power connection.ESCs without BEC power module: This type of ESC needs to be wired...

This article will teach you how to connect the USB parameter board and the parameter description of the software. The USB parameter board is suitable for ESCs: Feather 80A ESC, 100A ESC, Feather 200A ESC, 200A/300A ESC.Step 1: Connect the ESC signal line to the parameter board, the orange line to the yellow line, and the brown line to the brown line. As shown in the figure below: Step 2: Open the software compression package, then open the software folder, and finally open the application. Wait for a few seconds, and an option will pop up. Just close it; After...

This article mainly explains the usage and functions of the A300 remote control. How to use the remote control: First, we turn on the remote control, then connect the power supply, and wait for the device to pass the self-test before starting to use it. Push the remote control joystick upward, the left and right propellers blow air forward and move forward.Pull the remote control joystick downward, the left and right propellers blow air backward and move backward.Push the joystick to the left, the left propeller blows air backward, the right propeller blows air forward, and turns left.Push the joystick...